NIFF- T-SEAT

MODEL NTS2

PROVIDES 5" AND 11" SITTING ELEVATIONS OR 5" AND 16" SITTING ELEVATIONS

• THE NST2 CAN BE PROVIDED WITH A 6" STAKE OR AN 11" STAKE.

• THE 6" STAKE IS OFTEN THE BEST CHOICE IF YOU HAVE GOOD KNEES AND CAN SIT LOW.

THE LOWER ELEVATION IS MORE STABLE, EASY TO ROTATE AND PLACE A KNEE TO THE GROUND.  YOUR KNEES AND ELBOWS ARE IN GOOD PROXIMITY TO PROP FOR STEADY SHOOTING REST AND THE GROUND CAN BE REACHED TO PICK UP OR LAY DOWN A GAME CALL.

NIFF- T-SEAT

MODEL NTS4

PROVIDES 5", 11", 16" AND 22" SITTING ELEVATIONS

THE NTS4 IS THE MOST VERSATILE AND IS PROVIDED WITH BOTH THE 6" STAKE AND 11" STAKE.  CONNECT THE TWO STAKES TOGETHER FOR THE 22" HEIGHT.

READ BEFORE USING

NIFF- T-SEAT

1.  NEVER USE THIS PRODUCT ABOVE GROUND LEVEL.

2. NEVER CARRY YOUR SEAT FULLY ASSEMBLED WITH SPIKE SCREWED INTO STAKE AND STAKE POINTED UP.

3.  READ ASSEMBLY INSTRUCTIONS AND ALWAYS MAKE SURE ALL PARTS ARE PROPERLY ASSEMBLED BEFORE USING.

4.  INSPECT YOUR SEAT OFTEN TO MAKE SURE ALL PARTS ARE IN GOOD CONDITION AND SCREW PARTS ARE HAND TIGHT.

5.  ALWAYS SIT IN THE CENTER OF THE SEAT TO EVENLY DISTRIBUTE BODY WEIGHT.

6.  DO NOT USE IF BODY WEIGHT EXCEEDS 300 POUNDS.

7.  USE PLENTY OF COMMON SENSE WITH YOUR SEAT AND ENJOY YEARS OF SAFE USE.

WARRANTY

TWO YEARS FOR ANY PART FOUND DEFECTIVE DUE TO FAULTY MATERIAL OR WORKMANSHIP WHEN RETURNED, SHIPPING PREPAID, WILL BE REPAIRED OR REPLACED FREE.

RPM ENTERPRISES, INC.
2817 PLEASANT DRIVE
PASCAGOULA, MS 39581
(228) 769-7721

ASSEMBLY INSTRUCTIONS

FOR

NIFF- T-SEAT

ATTACH STAKE TO SEAT - ALIGN THE STAKE'S THREADED END WITH THE THREADED HOLE IN SEAT BASE.  HAND TIGHTEN TO SECURE STAKE TO SEAT BASE WHILE KEEPING IN MIND THAT THE STAKE MUST BE UNSCREWED BY HAND WHEN NOT IN USE.

ATTACH WASHER AND SPIKE TO STAKE OR SEAT BASE - PLACE THREADED END OF SPIKE THROUGH CENTER HOLE OF WASHER AND SCREW INTO BOTTOM END OF STAKE OR SEAT BASE.   FINGER TIGHTEN ONLY.  THE THREADS ON THE SPIKE HAVE BEEN CRIMPED TO ENSURE THE WASHER REMAINS LOOSE, ALLOWING FREEDOM TO PIVOT ASSEMBLED SEAT WHILE IN USE.

CARRYING T-SEAT FOLDED UP

INSERT YOUR BELT THROUGH THE SEWN LOOP ON ACCESSORY CARRY SNAP STRAP AND WEAR AROUND WAIST OR OVER SHOULDER AND SLIGHTLY TO YOUR BACK SIDE TO AVOID BUMPING METAL PARTS.  ALWAYS CHECK STAKE AND SPIKE FOR HAND TIGHTNESS TO PREVENT LOSS.

NOTE:  THE STAKE MAY BE DIFFICULT TO INSTALL INTO THE STAKE HOLDER THE FIRST TIME.  PULL UP ON THE SNAP AND WORK THE STAKE THROUGH THE HOLDER.  THE HOLDER IS TIGHT TO KEEP THE STAKE FROM CLANKING TOGETHER ON THE NTS4.

CARRYING T-SEAT ASSEMBLED

• THE CARRYING SNAP STRAP MAY BE SNAPPED AROUND SEAT SUPPORT BRACKETS AS SHOWN, BUT NEVER AROUND STAKE AT SUPPORT WASHER END WITH SPIKE POINTED UP.  WITH SPIKE END POINTED UP, A SLIP OR FALL COULD BE HAZARDOUS.  BE CAREFUL, TAKE CAUTION AND USE COMMON SENSE WHEN CARRYING NIFF - T - SEAT ASSEMBLED.

• WHEN MOVING FROM PLACE TO PLACE, ALWAYS CHECK STAKE AND SPIKE FOR HAND TIGHTNESS TO PREVENT LOSS.

MAINTENANCE

• TAKE CARE OF YOUR NIFF-T-SEAT.  DO NOT STORE IT OUTSIDE EXPOSED TO DAILY SUN OR RAIN.  THE OUTDOOR ELEMENTS WILL DETERIORATE THE SEAT'S FABRIC TOP AND METAL PARTS WILL RUST.

• SCREW THREADS ARE STEEL AND WILL RUST WHEN STORED DIRTY AND WET.   IT'S IMPORTANT TO KEEP SCREW THREADS CLEAN AND LUBRICATED TO ASSEMBLE OR DISASSEMBLE SEAT PARTS BY HAND.

• FOR WHATEVER REASON, IF FEMALE SCREW THREADS BECOME CLOGGED WITH DIRT OR RUST, USE A 5/16" X 18 THREAD TAP TO CLEAN AND THEN LUBRICATE.

• SPIKE AND STAKE MALE THREADS MAY BE WIRE BRUSHED TO CLEAN AND THEN LUBRICATE.

• IF NEEDED, A 1/2" BOX END WRENCH WILL FIT SPIKE NUT.

• THE O-RING ON SPIKE IS IMPORTANT TO KEEP THE SUPPORT WASHER FROM RINGING WHEN BUMPED.  THE O-RING IS A #111 BUNA AND MAY BE PURCHASED FROM YOUR LOCAL AUTO PARTS HOUSE.

SUGGESTIONS

SEAT USE IN MARSH, SOFT MUD AND DRY SAND

USE A PLASTIC BUCKET LID FROM A 2 GALLON OR A 5 GALLON BUCKET.  DRILL A 1/2" HOLE IN THE CENTER OF THE PLASTIC BUCKET LID AND ASSEMBLE AS SHOWN ABOVE.   THE PLASTIC LID WILL FLEX WITH THE SEAT MOVEMENTS.  A HARD MATERIAL SUCH AS STEEL OR PLYWOOD WILL BE TOO HARD AND OVERSTRESSES SEAT SPIKE AND STAKE THREADS.

NIFF- T-SEAT

AS A

SPECTATOR SEAT

• DOES NOT REQUIRE LEVEL GROUND TO SIT UP STRAIGHT.

• DOES NOT TURN OVER WHEN YOU STAND UP.

• ALLOWS COMFORTABLE SEATING IN FRONT OF A STANDING CROWD.

• PREVENTS CLOTHING FROM BECOMING SOILED AS WHEN SITTING ON THE GROUND.

• EASILY CARRIED WITH BELT THROUGH SEWN LOOP ON ACCESSORY CARRYING SNAP STRAP.

HELPFUL INFORMATION

NOTE:  TO MAINTAIN YOUR BALANCE, DO NOT PLACE THE SEAT DIRECTLY BETWEEN YOUR FEET, BUT SLIGHTLY BEHIND YOU.  ALWAYS KEEP YOUR FEET SPREAD APART AND SIT AS IF YOU WERE SITTING IN A STRAIGHT BACK CHAIR.

• THE SPIKE AND WASHER FOOT PREVENT THE SEAT FROM TURNING OVER WHEN YOU STAND UP.

• THREADED SCREW PARTS MAY BE LUBRICATED WITH A LUBRICANT OF YOUR CHOICE.   ARCHERY BOW STRING WAX WILL WORK AND HELP PREVENT THREADS FROM BACKING OUT AND LOSING SPIKE AND WASHER.

NIFF- T-SEAT

AS A

HUNTING ADVANTAGE

• LOW PROFILE - CAN BE USED WITH OR WITHOUT BACK SUPPORT.

• NATURAL SHOOTING POSITION - SITS LEVEL AND CLOSE TO TREE.

• COMPACT, EASILY TRANSPORTED, SWIVELS ON SINGLE FOOT PIVOT.

• COMFORTABLE SITTING POSITION, ALLOWING YOU TO SIT UNDETECTED LONGER - THE KEY TO SEEING MORE GAME.

NIFF- T-SEAT

• A STABLE SHOOTING REST MADE BY FORMING A BIPOD WITH A STICK AND A KNEE

• "QUICK CHANGE" ALLOWS YOU TO ATTACH OR REMOVE PEDESTAL LEG IN SECONDS.

• IT SWIVELS, ALLOWING YOU TO TURN WITHOUT NOISE.

• ELEVATED T-SEAT ALLOWS YOU TO SEE FURTHER BY LOOKING UNDER THE BROWSE LINE AND OVER KNEE HIGH VEGETATION TO SEE YOUR HUNTED GAME.

CAUTION

ALWAYS SIT IN THE CENTER OF THE T-SEAT TO EVENLY DISTRIBUTE YOUR BODY WEIGHT.  WRONG USE MAY DAMAGE THE SEAT BASE BRACKET.

NOISE REDUCTION

WHEN ASSEMBLING NIFF- T-SEAT IN A QUIET ENVIRONMENT, ALWAYS KEEP FINGERS IN CONTACT WITH WASHER TO DAMPEN METAL TO METAL CONTACT OR RINGING WHEN BUMPED WITH STAKE OR SPIKE.

OR YOU MAY

USE A 3" PIECE OF DUCT TAPE AND STICK 1/2" TO EACH SIDE OF THE SUPPORT WASHER AND PRESS TOGETHER TO MAKE A TAPE TAB ON ONE OR BOTH SIDES.  THIS   IS THE EASIEST WAY TO REDUCE THE HIGH PITCHED RING WHEN WASHER IS BUMPED.

VERSATILE CAPABILITIES

ADAPTS TO:

• BOW HUNTING - BY ALLOWING FREE AND QUIET MOVEMENT.

• PHOTOGRAPHY - BY SITTING UP CLOSE TO CAMERA AND TRIPOD.

• FISHING - FROM THE SHORE OF A POND OR STREAM.

• CAMPING - BY PROVIDING  A SEAT OFF THE WET, COLD GROUND.

• SPECTATOR FIELD SPORTS - BY PROVIDING PORTABLE, VERSATILE SEATING.

ADD AN EXTRA CUSHION TO SEAT TOP TO REMAIN COMFORTABLE ALL DAY.

MOVING OR DODDERING

• ANCHOR SEAT WITH LIGHT ROPE AND LEAN AGAINST THE ROPE'S RESISTANCE TO STOP MOVEMENT OR DODDERING.  THE ROPE WILL NOT HINDER THE ABILITY TO SWIVEL OR ROTATE THE SEAT.

THE EASY FIX IS TO JUST LEAN SLIGHTLY FORWARD ALLOWING YOUR LEGS TO HOLD RESISTANCE AGAINST THE LEANING SEAT AND MOVEMENT WILL STOP.